About this page

This page gives you information on how to set up Web Caster V130 for using the IP-Phone-C.

Before setting up

See the manual of the router/modem to set up.

1. STEP1

   Wiring

   Connect the IP-Phone supported device, computer, and your phone with cables.
   See the manual of the IP-Phone supported device for wiring instructions.
   See also if the ACR (LCR) function is disabled on your phone device.

2. STEP2

   Internet connection setup

   Set up the internet connection of IP-Phone supported device.

   • Internet Connection Settings for Web Caster V130
3. STEP3

   IP-Phone setup

   Set up your IP-Phone while you are connected to the internet.

   • Phone Function Settings for IP-Phone-C (Manual)
   • Phone Function Settings for IP-Phone-C (Automatic)

   After completing the setup, check your device’s lamp status if it is correctly connected.
   See the manual of your router/device for details.

   

   Correct status

   電源 (= Power)	Green light is on
   動作モード (= Operating mode)	Green light is on
   WAN	Green light is on
   PPP	Green light is on
   IP電話 (= IP-Phone)	Green light is on

How to use

See the following for how to use IP-Phone-C.

• Setup Guide: How to Use IP-Phone-C